| Subject | Text |
| Switch Ohmeter 10x you check D with S pin and change the pin again ,result the meter swing to high s |
| Capacitance meter. I have a fluke 175. You can find a capacitance meter on ebay for cheep. |
|
|
| how tocheck this transister sta 353 yy3 | how tocheck this transister
sta
353
yy3
what type of this transister
how to check its |
| Mike,
I am not familiar with the specific model but more likely you have a power supply issue. Disc |
| 400 volt capacitor how to know its leckage or damaged | The best way is to use a ESR meter but a standard capacitance meter would work also but not 100%.
A |
| 400 volt capacitor how to know its leckage or damaged | 400 volt capacitor how to know its leckage or damaged
one day my own digital satellite reciv |
| Re: Tape dack made by technics RS-TR373 does not play sound | <span class="notranslate" onmouseover="_tipon(this)" onmouseout="_tipoff |
| Re: philips 25gr | [quote:f15e5ef5bb="polaret"]Hello
I have a philips 25gr TV and the problem that i have is that aft |
| For Sale: Keithley 178 5 1/2 Digit Bench Digital Multimeter | For Sale: Keithley 178 5 1/2 Digit Digital Multimeter. It is a lab quality digital multimeter with a |
| Mystery Diodes | Well I'm new here and athough I know alot about tube equiptment I have limited knowledge of solid st |
| Panasonic CT32SS31 power | I have for repair a CT32SX31 set. I have no HV but power. When I plug it in I hear a high pitch and |
| If you get a diagram you can see what you are soldering:)
If not, replace the electrolytics around |
| Gents, l was working on the very same unit, with same problem.
Battling for 2 days and no luck.
|
| Can you measure resistance (Ohm) with your meter?
If so, a short should measure 0 - 10 Ohms
A go |
| Re: Goodmans GTV42P3 42" Plasma TV - Power Board Repair | [quote:ba34fe886c="Mad Professor"]Good Day All.
I have a 3 year old Goodmans GTV42P3 42" P |
| You can buy a ESR meter from MCM electronics for about $20.00 |
| Re: looking for | [quote:6e09f5f793="jts1957"]That's the "Location" and "Rating/Value" of [b:6e09f |
|
|
| Being a switchmode powersupply I would not run it without a load otherwise it may self destruct. Plu |
| Yikes! Now it's getting complicated! I found the Power Transistors and ordered them through
htt |
| Re: Viewsonic N3245W Black Screen - Need some help | I would like your old inverter board; have one with bad transformer on; can't find supply of board o |
| [quote:93e26ac61b="vtech"]Depends on your Amplifier drive capability; while it is not too far off, |
| Bush ws6671sil - 11AK19Pro chassis - Help needed! | Hello!
First off, this site is probably the most useful electronic repair site I have come across. |
| videocon microwave | Worth checking them anyway using a meter as they cause a lot of problems on all microwaves. |
| It sounds like it could be a capacitor related problem. Do you have an ESR meter to test them with? |
| Hello
You must meter output lines of power supply unit and check that their values being true (as s |
| the best procedure to check ultra fast diode by analogmeter | the best procedure to check ultra fast diode by analogmeter
what is the best procedure?
how t |
| There's no bulging caps that I can see on any of the boards, including the power supply.
So, I sh |
| PSU problem Infocus 5700 - heat up caps works | Hi all, I have an Infocus Screenplay 5700 projector with a PSU problem. It fails to startup unless I |
| Is it an Electrolytic ? If yes a esr meter, and or a capacitance meter. |
| Nd Svc Manuals - Fluke 8060A, Pana-KX-P4430laser | I looked here far and wide and have not found the manuals.
The KX-P 4430 is similar to several m |